|
|
HB-455 BLASTING MACHINE
|
Item Number: 5062
The HB-455 has a magnetic security key built into the machine. Simply remove it to disable the machine. This provides an extra safety measure. It also has a built in continuity indicator. HB-455 Scorpion Solid-State Electronic Fire Controlled Blasting Machine 450 VDC 68 uF Electrolytic Approximately 3 seconds (peak) High Intensity Green LED Intelligent Design / Range Specific FIRE CONTROL Approximately 16 oz. Black Hardware HD Black Nylon Plastic & Brass, SS 'D' Rings, Quick -Connect Binding Posts, Neck Strap Protected Recessed Pushbutton Yes. Sealed Electronics ELECTRICAL 450 VDC 5 Joules MECHANICAL Urethane Plastic 3"W x 5.25"L x 1.7"D F/C Resistance Range LED Indication Min. Amperage Fire Circuit 0 - 135 Ohms Green 3.3 Amps Released 136 - 205 Ohms Amber 2.2 Amps Released 206+ Ohms Red N/A Locked LED Indicator Powered by Polarity Waterproof Compartment Cover Caution: Do NOT relax CHARGE switch when depressing FIRE switch. The dual switch firing circuit assures the blasters intent to initiate. When READY light fails to illuminate within 5 seconds , replace the Heavy Duty Alkaline 9V battery accessible through the battery cap located on the right side of the unit Make note to insure proper polarity when replacing battery. Fire Control: Connect the blasting circuit to the output terminals located on the top of the machine. The HB -455 will check the resistance level of the attached blasting circuit and indicate the condition of the circuit by the LINE light; conditions listed above. The HB -455 will operate in the Green and Amber conditions, but operation will be locked out if the resistance is found to be above the condition listed for the Red Line condition. To Fire: Repeat CHARGE and FIRE sequence as in To Test.
|
|
|
|
|